Re: [CR]Re: Stronglight extractor thread

(Example: Production Builders:Peugeot)

Date: Thu, 11 May 2006 15:09:35 -0700 (PDT)
From: "Ted E. Baer" <wickedsky@sbcglobal.net>
Subject: Re: [CR]Re: Stronglight extractor thread
To: classicrendezvous@bikelist.org
In-Reply-To: <321.3be63a3.3194edd8@aol.com>


I was taught that Stronglight removal tools were 23.35mm (actually 23.35mm x 1.) Wanted to make sure so I checked an old "United Bicycle Tools" catalog that I have laying around dated spring/summer 1997. Flip to page 16. Third item down or the far right says: STRONGLIGHT CRANK EXTRACTOR: "Professional quality tool fits pre-1982 Stronglight cranks which had 23.35mm diameter threading. Use of any other tool in these cranks is likely to strip the threads. Professional quality. VR-22/2 $21.00."

Too HOT in Palo Alto, CA
Theodore Edward Baer


--- StuartMX4@aol.com wrote:


> Have I missed something? Without knowing the pitch,
> nobody who doesn't have
> a Stronglight extractor at hand will be able to
> recognise the thread. You need
> OD (which is not going to be as precise as two
> places of decimals) and the
> pitch either in metric or TPI.
>
> Stuart Tallack in West Sussex
>
>
> _______________________________________________
> Classicrendezvous mailing list
> Classicrendezvous@bikelist.org
> http://www.bikelist.org/mailman/listinfo/classicrendezvous
> _______________________________________________ Classicrendezvous mailing list Classicrendezvous@bikelist.org http://www.bikelist.org/mailman/listinfo/classicrendezvous