Re: [CR]Raleigh Super Course Mk II Spindle Interchangeability ?

(Example: Component Manufacturers:Avocet)

Date: Fri, 9 Jun 2006 11:06:38 -0700 (PDT)
From: "r cielec" <teaat4p@yahoo.com>
Subject: Re: [CR]Raleigh Super Course Mk II Spindle Interchangeability ?
To: Jerome & Elizabeth Moos <jerrymoos@sbcglobal.net>, Classic Rendezvous <classicrendezvous@bikelist.org>
In-Reply-To: <20060609173839.10943.qmail@web82211.mail.mud.yahoo.com>


Jerry:

Thanks for looking over my shoulder and checking. I can certainly use it.

No, I will not be using the Stronglight 93 crank. Removal of the Stronglight 93 is the reason for the need of a different spindle. Replacement crank to be determined: Campag or Raleigh-badged SR. I assume both of these are ISO.

Richard Cielec Chicago, Illinois; U.S.A.

Jerome & Elizabeth Moos <jerrymoos@sbcglobal.net> wrote: Richard, are you going to use the original Stronglight cranks? If so, there may be a problem using an ISO taper. Stronglight arms would sometime "bottom out" on ISO (Campy and clone) tapers, that is, the inside of the crank would hit the inside end of the taper before the crank arm tightened up on the taper. In this situation, continuing to to tighten the crank bolts will achieve nothing except perhaps snapping the heads off the bolts. This was a separate problem from whether you have the right axle length. JIS tapers, on the other hand, usually worked OK with Stronglight arms.

Regards,

Jerry Moos

r cielec <teaat4p@yahoo.com> wrote: Ahoy !

I have need of determing the proper bottom bracket spindle length and off-set.

I wish to install an ISO taper bb spindle (Read: Not Stronglight taper) within a 1974 Raleigh Super Course Mk. II.

Would the same spindle specification be common to all the Raleigh Reynolds 531 frames? Thas is: Super Course Mk. II, International, Gran Sport, Competition and possibly Pro. (Yes, I am aware that the infamous Campag vs. CPSC (abbrv?) issue may be relevant here.) I am hoping the number stamped into an International spndle will serve me to shop for what is needed.

Why am I asking? For reason that I have completely forgotton how to measure a spindle. Well, it's been a long, long time. For measuring, I do need to see the illustration as to where one actually reads the dimension.

Thank you.

Regards,

Richard Cielec Chicago, Illinois; U.S.A.

__________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com

_______________________________________________

__________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com