I have this SunTour tool as well as a ValCan slide hammer cartridge bearing puller. The ValCan is MUCH better a tool, at a higher cost though. A spike/common nail about 6"-8" long, with the point rounded and the flat head ground to just fit in the cups axle hole works really well too for the Campy hubs.
Andy Stewart
Raleigh, NC
> ------------------------------
>
> Date: Tue, 11 Mar 2008 07:17:50 -0700 (PDT)
> From: jeffrey piwonka <jmpiwonka@yahoo.com>
> To: Classicrendezvous@bikelist.org
> Subject: re: [CR]Rebuilding Campagnolo NR Hubs
> Message-ID: <31025.18171.qm@web82712.mail.mud.yahoo.com>
> In-Reply-To: <46015.12.2.142.7.1205242534.squirrel@webmail.mtco.com>
> Content-Type: text/plain; charset=iso-8859-1
> MIME-Version: 1.0
> Content-Transfer-Encoding: 8bit
> Precedence: list
> Message: 12
>
> i thought for five bucks this wasn't a bad tool to
> have if i ever decided to mess with the cups.
> http://www.loosescrews.com/
>
> Jeff Piwonka
> austin, texas usa.
>
>
> --- kurtsj@mtco.com wrote:
>
>> From: "Don Williams" <donwilliamsjr(AT)gmail.com>
>>
>> "I'm out to rebuild some campy HR hubs...
>>
>> I need to know how to remove and replace the bearing
>> cups (races).
>>
>> I vaguely remember pounding out* and pressing in
>> cups 35 years ago,
>> but most details are gone into the dark murk that is
>> my "memory" "
>>
>>
>> hi Don,
>>
>> I don't know the secret techniques, but I do know
>> that Peter Jon White
>> still knows them. He replaced the cups on a Campy
>> Record rear hub for me
>> a few years back.
>> http://www.peterwhitecycles.com/
>>
>> Otherwise, you might want to search the CR archives
>> on the subject.
>>
>> good luck,
>> Steve Kurt
>> Peoria, IL
>>
>>
>> _______________________________________________
>> Classicrendezvous mailing list
>> Classicrendezvous@bikelist.org
>>
_______________________________________________
Classicrendezvous mailing list
Classicrendezvous@bikelist.org
http://www.bikelist.org/