Re: [CR]GB Bars for '74 Raleigh Pro??

(Example: Production Builders:Tonard)

Date: Fri, 15 Dec 2000 14:18:38 -0500
From: Jerry Moos <moos@penn.com>
To: Larry Osborn <losborn2@wvu.edu>
CC: classicrendezvous@bikelist.org
Subject: Re: [CR]GB Bars for '74 Raleigh Pro??
References: <3.0.1.32.20001215134842.006dfa10@wvu.edu>


This all reminds me, the similarly (nearly identically) engraved GB randonneur bend bars I recently purchased are not 26.0mm, but 1" (25.4mm). Were the maes bend GBs on the Raleigh Pros 26.0mm to fit the TTT stems, or did Raleigh just overtighten the TTT clamp bolts a bit? I suppose TTT could have made 1" clamp stems for Raleigh, but somehow I doubt this.

Regards,

Jerry Moos

Larry Osborn wrote:
> At 01:40 PM 12/15/00 EST, you wrote:
> >In a message dated 12/15/00 1:36:25 PM Eastern Standard Time,
> >losborn2@wvu.edu writes:
> >
> >> All together now..... tear the tape off your GBs and tell us what you find,
> >> besides cracks and corrosion.
> >>
> >I was going to ask about that.......
> >Are there cracking issues involved with all that engraving? Or is it all
> >actually stamped in?
>
> I'm sure it's just stamped in. Never seen a GB crack in the "engraved"
> area. Inboard around the clamping area, and outboard near the first bend, yes.
>
> >I was going to cheat, TTT record stem with any bar that works and go ride!
> >
>
> Larry "Whatever gets it on the road, NOW! Corrections and improvements if
> and when the opportunities arise" Osborn
>
> >Pete Geurds
> >Douglassville, Pa
> >
>
> _______________________________________________

Larry Osborn wrote:
> At 01:40 PM 12/15/00 EST, you wrote:
> >In a message dated 12/15/00 1:36:25 PM Eastern Standard Time,
> >losborn2@wvu.edu writes:
> >
> >> All together now..... tear the tape off your GBs and tell us what you find,
> >> besides cracks and corrosion.
> >>
> >I was going to ask about that.......
> >Are there cracking issues involved with all that engraving? Or is it all
> >actually stamped in?
>
> I'm sure it's just stamped in. Never seen a GB crack in the "engraved"
> area. Inboard around the clamping area, and outboard near the first bend, yes.
>
> >I was going to cheat, TTT record stem with any bar that works and go ride!
> >
>
> Larry "Whatever gets it on the road, NOW! Corrections and improvements if
> and when the opportunities arise" Osborn
>
> >Pete Geurds
> >Douglassville, Pa