Re: [CR]Seeking Stronglight headset tips

(Example: Production Builders:Frejus)

Date: Tue, 19 Dec 2000 21:57:05 -0500
From: Jerry & Liz Moos <moos@penn.com>
To: don andersen <peugeotpx10@hotmail.com>
CC: classicrendezvous@bikelist.org
Subject: Re: [CR]Seeking Stronglight headset tips
References: <F194Oiy54DgI6bXmdMJ00004019@hotmail.com>


Craig, Loose Screws sells Hozan Head Race Pliers, which have large curved serrated jaws which grip the top cup with less potential damage than channel locks. IF you buy from Loose Screws, do it soon, they are having a liquidition sale.

Regards,

Jerry Moos

don andersen wrote:
> Craig, I am far from an expert on anything but I have installed several of
> these headsets. Thread the cup onto the fork threads until you seat the
> bearings. Now back off a 1/4 turn and slide the toothed washer down,
> locking the teeth to the top of the cup. Then you need to slide a locking
> washer down on top of the tooth-washer. Depending on the bike, you need
> either a flat sided or "pronged" lock washer. Then screw down the locking
> nut. The locking washer should keep the cup from turning when you tighten
> the lock nut. If the locking washer begins to slip, then use a pair of
> large chanel locks-protecting the cup with a rag or something and turn the
> nut, not the cup. If you are using a centerpull brake cable stop, some have
> an integrated tange to act as the locking washer. This should do the trick.
> If you are still having trouble, clean the threads good and wrap some
> teflon tape around them before screwing down the nut. As always, preloading
> the bearings is hit and miss. Use Grade 25 bearings, don't over pack and
> not too tight as too induce indexing. Oh, if this is a headset that already
> indexes and it has the "V" shaped races, try the next size larger bearing
> on the lower race. I've done it and it works fine. Those headsets are
> sometimes hard to find in the "right" size so improvising may help you
> retain the original. Our local builder/shop owner/racer, Glenn Swan, turned
> down my pitted race on his lathe (in the winter when he was not busy). Good
> Luck. I hope I was able to help.
>
> Don Andersen
>
> >French bike experts,
> >I have one of the old all-steel Stronglight
> >headsets with the toothed washer. The only
> >provision for tightening with tools are
> >pin holes in the top nut (my green park
> >spanner fits these), and pin holes in the
> >sides of the toothed washer (no tool I
> >have works with these).
> >
> >What are the proper tools and protocol to
> >tighten this headset? I've been setting
> >the threaded race by hand, then tightening
> >the top nut against it. This is not doing the
> >job.
> >
> >thanks,
> >- Craig Sandvik
> > Clear skies but clouded sinuses in Berkeley, CA
> >
> >__________________________________________________
> >Do You Yahoo!?
> >Yahoo! Shopping - Thousands of Stores. Millions of Products.
> >http://shopping.yahoo.com/