In a message dated 3/9/01 8:27:06 AM EST, davidg@iag.net writes:
> the races and clean the old grease
> I found two different sizes of bearings. The rear bearings were 1/4" and
> there were nine in each side. The front hub had 7/32" bearings, also with
> nine in each side. Now I've never disassembled a Campy hub before so I'm
> unfamiliar with the proper bearing sizes. Are these sizes correct for these
> hubs? Also, there are numbers on the cones the rear have 10x26 and the
front
> have 9x25 or 26 (the numbers are hard to read), what do these stand for?
Sounds correct.
The 10 x 26, and 9 x 26 refer to the threading, 10mm x 26 TPI (threads per
inch).
see: http://www.bikindex.com/
Pete Geurds
Douglassville, PA