Re: [CR]Kroil


Example: Component Manufacturers:Campagnolo
Date: Wed, 29 Aug 2001 19:21:49 -0700
From: "Chuck Schmidt" <chuckschmidt@earthlink.net>
To: classicrendezvous@bikelist.org
Subject: Re: [CR]Kroil
References: <96.1972cb05.28bef3a0@aol.com> <3B8D8DFD.569E@adnc.com>


Aero Kroil... The Oil That Creeps... LOOSENS FROZEN METAL PARTS A scientific discovery reduces the surface tension so that this amazing solvent creeps into openings as small as one millionth of an inch. Wherever there is corrosion -due to heat, salt water, chemical action, or weathering Kroil will loosen metal joints in a few minutes' time, saving labor, equipment and temper. It dissolves gum, dried grease and oil, removes rust and carbon deposits - without attacking the metal - and provides proper lubrication. Resists wetting so prevents rust.

KANO Aerokroil •Loosens the toughest stuck together metal parts or your money back. •No harm to metal or skin...prevents rust. •Use Kroil to loosen nuts, bolts, studs, screws, pulleys, shafts, bearings, guns, pipe threads, valve guides or any corroded metal parts...for lubricating air driven tools...for removing rust, gummed oil and grease...for cleaning cement tools.

DIRECTIONS Remove protecting dome. Point nozzle at the work and push the valve, squirt Kroil as close to the joint as possible; wait a minute before turning depending on the size and condition of the parts.

Order Direct From KANO LABORATORIES (615) 833-4101

Chuck Schmidt SoPas, SoCal

Brian Baylis wrote:
>
> Dale,
>
> Just like it says, it's for oiling krows.
>
> Brian (OK, I'll shut up now) Baylis
> La Mesa, CA
> >
> > In a message dated 8/29/01 9:22:16 PM Eastern Daylight Time,
> > RALEIGH531@aol.com writes:
> >
> > << Kroil >>
> >
> > OK, I give up. What is Kroil? What do they say on the can it is to be used
> > for?
> >
> > Dale Brown
> > Greensboro, North Carolina