Re: [CR]French thread pedals

(Example: Framebuilding:Paint)

From: Jerry & Liz Moos <jerrymoos@sbcglobal.net>
To: "Rick Chasteen" <rchasteen@kc.rr.com>, <classicrendezvous@bikelist.org>, "Sheldon Brown" <CaptBike@sheldonbrown.com>
References: <016301c1ce38$051c0f60$923a1a41@kc.rr.com> <v04210109b8bb2a36d677@[10.0.1.13]>
Subject: Re: [CR]French thread pedals
Date: Sat, 23 Mar 2002 12:12:43 -0600


While many French-threaded pedals are marked D and G, some are not marked at all. In these cases I simply (carefully) try threading them into a known French-threaded crank arm. If no threads are damaged on the arm or pedals, a French-threaded pedal should thread into a French-threaded crank smoothly using only moderate hand force. After a couple of turns, an English-threaded pedal will tighten up in a French crank. You can thread it all the way in using a wrench, but doing so will damage the threads. I'll bet there are a lot of old French cranks out there with English pedals that were forced in by some teenaged bike shop mechanic who never heard of French threads. Conversely, the English-threaded Stronglight cranks on my 1973 LeJeune actually came with French-threaded Lyotard pedals which I unknowingly rode for some time before replacing them with more expensive pedals. Evidently, the pedals had been tightened enough to prevent them working loose despite the undersized thread. I was lucky, as this combination will usually result in the French pedal moving around enough to damage the crank thread.

Regards,

Jerry Moos


----- Original Message -----
From: Sheldon Brown
To: Rick Chasteen
Sent: Sunday, March 17, 2002 11:31 PM
Subject: Re: [CR]French thread pedals


Rick Chasteen a démandé:
>Is it possible to differentiate between French and BSC pedal threads
>visually, sans thread gauge? Can French threaded pedals be
>installed on BSC threaded crankarms and vice versa without great
>force and obvious thread damage to the crankarm?

French thread pedals will be marked "D" and "G" for "droite" (right) and "gauche" (left).

French thread pedals are a bit undersized for standard 9/16" - 20 thread cranks.

French-thread (14 x 1.25) cranks can be retapped to standard size, and many existing cranksets marked that way have already had this done.

Sheldon "Filetage français" Brown Newtonville, Massachusetts +--------------------------------------------------+ | If you find yourself standing to accelerate, | | on level ground, it is a sign that your gear | | is too high, or that your saddle is too low. | | See: http://sheldonbrown.com/standing.html | +--------------------------------------------------+

Harris Cyclery, West Newton, Massachusetts Phone 617-244-9772, 617-244-1040, FAX 617-244-1041
           http://harriscyclery.com
      Hard-to-find parts shipped Worldwide
           http://captainbike.com
   Useful articles about bicycles and cycling
           http://sheldonbrown.com