In a message dated 6/27/2 6:52:23 PM, Grant.McLean@SportingLife.ca writes:
>Unfortunately, someone got real happy with the cutter, and went way further
>
>than a 2mm taper, and actually reduced the shell width to about 65mm.
>The
>
>right side is not too bad, the fixed cup will hold, but the left side was
>
>sharpened to a point, and the lockring has flanged the shell to the point
>it
>
>is very visible, and the lock ring threads very far onto the cup.
Have it faced slightly to put a flat on it and if the cosmetics of having a
lot of thread showing bothers you put a spacer in. The drive side is where
the width of the shell matters and, again, if you need to install a spacer to
get the correct chainline.
Phil Brown
NoHo, Ca