Hello Greg, this case is not closed...
<<> Mark is correct. There never was an NR triple BB spindle.>>
I agree that there were never any NR Triple BBs, but I still stand by my assertion that the cups for #746 and #745 RECORD seem to be the same as NR 746/A and 745/A cups used on the NR... can anyone else clarify this?
<<Pg 31 Note the difference in bearing shoulder spacing between the 1046 set (wider spacing, Record), and the 1046/A set (narrower spacing, Nuovo Record).>>
In your quick review of Pg 31, you may have missed that the 1046/3 Record triple axle is not even pictured for comparison. The 1046 and 1046A pics seem to be taken from different angles. Therefore, I would not draw hasty conclusions unless a true picture comparison of NR vs Triple axles can be made.
Regards, Steve Neago
Cincinnati, OH
> All:
>
> Mark is correct. There never was an NR triple BB spindle.
>
> The 1982 catalog, on page 32, which I am looking at right now, shows a
744/1
> triple spindle, along with #746 and #745 RECORD non-rifled cups.
>
> The NR cups are part numbers 746/A and 745/A. These are to be used with
the
> 744/A Nuovo Record spindle.
>
> Page 31 of the same catalog actually shows the spindle differences much
> better. Note the difference in bearing shoulder spacing between the 1046
set
> (wider spacing, Record), and the 1046/A set (narrower spacing, Nuovo
Record).
>
> End of story.
>
> Greg Parker
> A@ MI USA
>
> In a message dated 6/8/02 2:54:31 AM Eastern Daylight Time,
> classicrendezvous-request@bikelist.org writes:
>
>
> > Message: 18
> > From: Mark Bulgier <mark@bulgier.net>
> > To: 'Steve Neago' <questor@cinci.rr.com>
> > Cc: classicrendezvous@bikelist.org
> > Subject: RE: [CR]WTB: Seeking Campy NR Triple BB
> > Date: Fri, 7 Jun 2002 20:42:08 -0700
> >
> >
> > I said that Campy never made a Nuovo Record (thick cup) Triple BB;
> > Steve Neago replies:
> >
> > > Thanks for the info, but please refer to the Campy 1982
> > > catalogue Pg 32... it lists a "744/1 Triple chainring
> > > cotterless spindle" which uses the same cups as a NR
> > > spindle listed directly below the triple spindle.
> >
> > Well I'll be - I apologize for the misinformation.
> >
> > Anyone ever actually seen this axle, or could it be something that
existed
> > only in a catalog? It sure seems like it must be much rarer than the
> > thin-cup triple axle, which is still easy to find to this day.
> >
> > Mark Bulgier
> > Seattle, Wa
> > USA