Re: [CR]Re Help Needed :Disassembling 3 piece hubs

(Example: Racing:Wayne Stetina)

From: "Stephen Barner" <steve@sburl.com>
To: <classicrendezvous@bikelist.org>
References: <CATFOODpBWFfPKeXXxK00001a16@catfood.nt.phred.org>
Subject: Re: [CR]Re Help Needed :Disassembling 3 piece hubs
Date: Wed, 23 Jul 2003 22:19:38 -0400


It's tough to argue with experience, but I would pull on a bearing seperator, not the flanges themselves. If I coudn't find a way to get the separator to bear on the smaller diameter inside of the flange, I would machine a suitable ring as a spacer, then cut it in half. The idea is to bear as uniformly on the flange as possible, as close to the center as possible. There is just too much chance that a 3-way puller will warp the flanges to make me feel comfortable with it.

Steve Barner, who was the only one who showed up at the time trial in the rain tonight--those other riders must not have fenders like the ones on my '77 Paramount--but rode the course at full-bore anyway, Bolton, Vermont

--and with all those imaginary people lining the road chanting "Lance-Lance-Lance." Guess they don't know my name isn't Lance.

----- Original Message -----
> Date: Wed, 23 Jul 2003 22:30:13 +0100
> From: "Pete Paine" <petebike7@btopenworld.com>
> To: <classicrendezvous@bikelist.org>
> Subject: [CR]Re Help Needed :Disassembling 3 piece hubs
>
> Brian I use a three legged automotive puller and find that will do most =
> hubs. This can be used directly on small flange hubs
> using a little heat on the alloy. On rear large flange double sided =
> hubs , screw on a cog and pull on that.=20
> On plain large flanges I made up a puller that worked though
> the large holes , again a little heat works wonders
>
> Cheers Pete Paine Watford