In a message dated 1/25/2003 8:43:17 PM Eastern Standard Time, nickzz@mindspring.com writes:
my additions<>
Larry Black
>
> Down tube clip
<or bz bosses>
>
> R.H./L.H. Plate
>
<sleel on clamp-on, with or without cable stop>
alloy for bz-on
> Metal washer
>
<Built-in/pressed on steel for clamp on
aluminum or delrin for bz-on>
> Control lever
>
<more concave side outward>
> Metal washer
>
<earlier mod. thin pressure washer, 'double-D' hole in center, followed by
chromed pressure backing plate>
<later models, delrin 'double-D' pressure plate followed by conical (cone-side out)backing pressure washer, followed by teensy lackwasher>
> Adjusting Screw
>
<with foldable wing ring>
> Is this the correct set-up!!!!
>
> Nick Zatezalo
> Atlanta,Ga
>
That's it.
Too far to go downstairs for part numbers off my catalogue attached to my
fake-wood service center cabninet, a relic in itself
Larry Black
Mt airy, Md.