Quality Bicycle Products used to make a cable stop that clamped onto the stem itself around the quill section.
You might check with your LBS and see if they can order you one.
Karen Rawls
Winchester (Finally summer) VA
> For various reasons, I want to use a set of center pull brakes (Mafac
Racers) on a frame that has a Campy NR headset installed and no room for a
normal Centerpull housing stop in the headset. The fork appears to be
trimmed too short (threads on the lock nut only 2/3 engaged and no spacers
in the headset) to accomodate even the thin Mafac hanger. I can replace the
headset with a lower stack headset like a Ritchey that would leave room for
the hanger, but that option doesn't really appeal to me. I'd like to keep
the appearance fairly traditional and early 60's. Hence the Mafacs and
Campy headset.
>
>
>
> What options are there for obtaining a hanger on this bike? Can I put the
hanger on top of the lock nut, and attach it to the nut? Could you remove
it later?
>
>
>
> Can I grind down one of the headset components to make the room? (least
favored option as it degrades the condition of the headset).
>
>
>
> Or should I drill a cable route/stop through the stem? The stem is a
Nitto Technomics with a 9cm extension. Would a drilled Nitto stem be safe?
How big do you make the top and bottom holes? How far out on the extension
do you drill?
>
>
>
> Or does someone have a better idea?
>
>
>
> Okay guys, get creative.
>
>
>
>
>
> Tom Adams, Shrewsbury NJ
>
>
>
> ------------------------------------------
> MSN 8 helps
> ------------------------------------------
> ELIMINATE E-MAIL VIRUSES.
> ------------------------------------------
> Get 2 months FREE*.