In a message dated 7/4/03 11:29:21 PM, classicrendezvous-request@bikelist.org
writes:
>Bryon,
>
>I bought a Stronglight crank puller from Harris Cyclery. It cost $49.00
>but it worked on a crank that was stuck for years. Stronglight cranks
>are 23.35mm. It helps to have a 19mm box end wrench to use with this tool
>
>Daniel S. Swords
>New Orleans, LA
>
>Bryon Wright <Starstryke25@netscape.net> wrote:
>thanks for the help on removing the dustcaps. I then went to remove the
>crankarms and my crankarm pullers are too small to fit the seemingly
oversized
>crankarm thread (I can just pop the entire threaded part of the tool in
>without touching the crankarm threads). Can anyone suggest a tool to use
>to remove these crankarms? Also, will a modern crankset fit onto the bottom
>bracket that the Stronglight crankset was attached too.
>
>-Bryon "the newb" Wright
>Antioch, CA
Hi all,
Daniel is correct. The TA tool side of the Park reversible tool will pull threads out of the old Stronglight. An old shop should have the tool so you have a cheapie source certainly if you pay them. I'd advise putting in a Phil (designed to fit) and keep the crank if the ring range is good for you as a well maintained Stronglight crank is as long lasting (and light) as your might find anywhere from my experience. They can polish up like a mirror too.
Looking around I have Stronglight (new and vintage) along with a few TA (Cyclotourist) cranks on everything I ride (6 bikes not including a few roadsters). The new cranks (Stronglight and TA) are hard to find but very nice as well.
I need a life man,
Gilbert Anderson
North Road Bicycle Company
519 W. North St.
Raleigh, NC 27603
USA
Toll Free Ph: 800\u2022321\u20225511
Local Ph: 919\u2022828\u20228999
E-mail: cyclestore@aol.com