I would be surprised if the Craftsman socket fit in the Zeus
cavity. I tried a Craftsman 5/8" socket (5/8" is .01" smaller
than 16mm) and it definitely did not fit. Of course, anything
is possible...
Fred Rednor - Arlington, Virginia
> That Zeus arm (I have several like it) has the 22.0mm Campy
> extractor thread. But I don't know if that is to the the
> base or the crest of the thread. The thread depth is
> probably about 1mm, so which way the thread diameter is
> measured would determine whether a 21.8mm OD socket would fit
> or not. You probably have to try it and see.
>
> Regards,
>
> Jerry Moos
> Houston, TX
>
> John Everett <jeverett3@earthlink.net> wrote:
> On 3 Dec 2004 at 16:00, gpvb1@comcast.net wrote:
>
> > Does anyone have an UNMODIFIED 16mm socket that works on a
> Zeus crank
> > arm, and if so, what brand & drive size is it so I can get
> one? The
> > wall would have to be incredibly thin, so personally, I
> doubt any
> > unmodified socket will work. Greg Parker Dexter, Michigan
>
> If the ID of the recess in a Zeus crank is indeed 22mm, as
> suggested by
> John Thompson, then the Craftsman 44311, with an OD of 21.8mm
> should
> work. Perhaps I should bring mine along next time I'm in the
> AA area (I get
> there often) and we could give it a try. :-)
>
> Or you could put the bike in your car and haul it over to the
> Sears at
> Briarwood and try one out. ;-)
>
> John Everett - Aurora, Illinois
>
>
> jeverett3@earthlink.net (John V. Everett)
>
>
>
> _______________________________________________
>
>
> _______________________________________________
>
__________________________________
Do you Yahoo!?
Read only the mail you want - Yahoo! Mail SpamGuard.
http://promotions.yahoo.com/