Hi all, I was polishing the shell of my small flange rear hub when I noticed the spoke holes were drill a little out of evenness, to the extent that when you look at them they look like they are drilled in pairs, the barrel of the hub was also a bit rippely, will have to put some calipers on them to get the measurements, is this normal?, or was it just a day the machinery went wonky?, I have no other pista hubs to compare with, never noticed this on any of my road hubs before. It is a 32 hole hub and cannot find any dates on the locknuts, so unable to ID a date....regards wayne davidson Invers NZ......