From: "Steven Willis" <smwillis@verizon.net> Subject: Re: [CR]Detecting French Freewheel threads in the field
> Also remember we measured it out at 34.7 and that should be French but the
> French will not go on. I also put a tread gauge on it and it too says
> French. So, did the Zeus co. use some offbeat tread angle? Steven
> Steven Willis
> 1778 East Second Street
> Scotch Plains NJ 07076
> 908-322-3330
> http://www.thebikestand.com
Thanks for bringing this up Tom. I have a couple Cyclo freewheels. I was trying to decide if they were French threaded or not. Is there a reliable figure for the ID of a French freewheel? As opposed to the OD of the hub, which is usually the measurement given. Funny thing is I don't seem to have a French threaded hub around. hmm...............
Pete Geurds
Douglassville, Pa