Don't the Victory cranksets uset the same bottom brackets as
the later NR/SR cranks? If that's the case, a 115mm
spindle/cup set - either NR (thick wall cups) or Gran Sport
(thin wall cups) should work.
Cheers,
Fred Rednor - Arlington, Virginia - USA
> IP Merkin wrote:
>
> >I have a Victory double crankset that I want to install on
> an old Italian
> > frame, but need help to get the bottom bracket spindle
> length. I've heard
> > 109
> > (and was fixing to buy a NOS square taper Shimano with
> 110), but then saw
> > a
> > Victory BB (English) on ebay that claimed a spindle length
> of 112. Can
> > someone tell me for certain? If I have to end up using
> something modern
> > like a
> > UN-52, is there a taper different that I need to take into
> account?
> > Apologies
> > in advance if I'm skirting the timeline a bit too closely.
>
> If you measure the distance across the flats, you'll see that
> the
> Campy/clones/Stronglight/etc. spindles are thinner, so a
> Shimano or other
> JIS-standard spindle won't go as far into the hole in the
> crankarms. This
> will make the JIS spindle effectively about 5.5mm longer
> (2.75mm each end)
> as far as your chainline and Q-factor are concerned. This
> fitment is
> generally not recommended, though I know of folks who did
> this and I
> witnessed that their chainrings remained perfectly in-plane
> and that is was
> reliable in these cases.
> Measured at about 3mm from the end, a Campy-type (ISO)
> spindle measures
> about 12.7mm across, while a JIS spindle measures about
> 12.9mm across. The
> taper angle (included angle) between opposite flats is
> exactly 2-degrees for
> both types. This translates to just under 3mm difference in
> terms of the
> depth that the spindle enters each crankarm.
> I'm not sure what length spindle Victory used. In these
> cases I typically
> test-fit a known spindle that's my best guess, then bolt on
> the right arm
> and check for chainring clearance. I often use
> shorter-than-spec spindle
> lengths to improve chainline on the bigger ring and cogs.
>
> David Snyder
> Auburn, CA
> USA
> Mars
__________________________________
Do you Yahoo!?
Yahoo! Small Business - Try our new resources site!
http://smallbusiness.yahoo.com/