[CR]Paint removal

(Example: Component Manufacturers:Chater-Lea)

From: "II LONG" <r4959l@msn.com>
To: classicrendezvous@bikelist.org
Date: Sun, 11 Jun 2006 16:32:23 +0000
Subject: [CR]Paint removal

I'm getting ready for the painter and am concerned if I should remove the original paint (trashed) with chemical remover before sending it to his sand blaster. I worry about sand blasting these old Vitus 888 tubes too much and would prefer to massage them a little if necessary. The paint layer appears to be quite thin at this point. Any suggestions for procedure? Flame away.

rlong