Re: [CR]Re: Pro's using Drillium components

(Example: Framebuilders:Pino Morroni)

Date: Sat, 14 Jan 2006 21:57:04 -0500
From: <oroboyz@aol.com>
References: <256.4934f94.30f70f9c@aol.com>
In-Reply-To: <256.4934f94.30f70f9c@aol.com>
Subject: Re: [CR]Re: Pro's using Drillium components
To: FujiFish1@aol.com, classicrendezvous@bikelist.org


<< ....and perhaps even his spider arms milled out already as well (too difficult to tell).

http://www.thehortoncollection.com/merckx1970a.htm >>

An old post I know(Still catching up!)

but there is no question that Eddy's spider arms are milled out. You wouldn't be able to see anything from the back side if they were still fluted... Clearly in that photo you can see the milling.... Good work, Mark!

Dale Brown Greensboro, NC USA

-----Original Message----- From: FujiFish1@aol.com To: classicrendezvous@bikelist.org Sent: Wed, 11 Jan 2006 20:49:16 EST Subject: [CR]Re: Pro's using Drillium components

>From another thread, Bret Horton posted the link below, to a c.1970 Kessels-Merckx brochure cover. If you zoom in on Eddy's bike, you will see that his post has been widely fluted, chainrings have been drilled, and perhaps even his spider arms milled out already as well (too difficult to tell). He also has hoods on his shift levers. Again, that's 1970...

Ciao, Mark Agree Southfield MI USA ~ ~ ~

Date: Wed, 11 Jan 2006 12:12:41 -0800 (PST) From: Brett Horton <bretthorton@thehortoncollection.com> (ALTERNATE)Subject: [CR]Merckx Cycles / Kessels - Start Date

There has been considerable discussion on the list over the years about the Falcon-Merckx mass produced bikes. What I am trying to determine is which came first: Falcon-Merckx or Kessels-Merckx mass produced bikes?

I was pawing through a new-to-me crate of cycling paper swag and came across a Kessels-Merckx catalog from what appears to be 1970.

Front Cover: http://www.thehortoncollection.com/merckx1970a.htm