I cannot address the re-thread issue. Although, for separating spindle from crank arm, have you tried a press? Sometimes, a home bench vise can be adapted if the vise is has a large enough maw.
Richard Cielec Chicago, Illinois; U.S.A.
dan polito <thepandle@hotmail.com> wrote: all- i have a TA 5-pin crank set on which the drive side extractor bolts are stripped out. i had enough room to take the chainring off, and then take out the entire bottom bracket assembly from the fixed cup side. of course, i can't separate the spindle from the arm.
anyway, is there a way to rethread this so to make it functioning? i thought i read someone mention that it could be rethreaded to fit a stronglight extractor. i searched through the archives, and could not find the post.
thoughts and recommendations?
thanks dan polito bloomington, IN
_______________________________________________
__________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com