Sure - just bear in mind that a spacer of the adjustable cup
has no effect on the chain line. If used one the adjustable
cup, it would only affect whether or not any extra threads were
visible. In fact, if used on the adjustable cup, a spacer
might prevent you from making the lock ring sufficiently tight.
Good luck,
Fred Rednor - Arlington, Virginia (USA)
> I agree, go with a 70mm formfactor spindle to start, BUT one
> cannot assume that all the material was taken from one side
> or equally from either side, as a result, test the chainline
> after assembly of the bb and with the drive side crank
> attached.
>
> Then decide on where the spacer(s) should go.
>
> John Jorgensen
> Torrance Ca USA
> _______________________________________________
>
__________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com