Fwd: Re: [CR] Seat post shims

(Example: Framebuilders:Bernard Carré)

Date: Fri, 2 Nov 2007 01:42:00 -0700 (PDT)
From: "Art Link" <artlink@columnssanantonio.com>
Subject: Fwd: Re: [CR] Seat post shims
To: classic rendezvous <classicrendezvous@bikelist.org>


I have used aluminum strips cut from soda cans with a scissor as shims and found no problem with them wanting to slide into the seat tube. You can always stuff a bit of tissue paper down the tube to the lower insertion point or run the shank of a screwdriver around the upper edge as it protrudes just above the seat tube to flare it out a bit These shims are cheap and almost infinitely variable for "fleshing out" the required dimensions. Art-I'll drink to that- Link,San Antonio,TX,USA

Stronglight49@aol.com wrote: From: Stronglight49@aol.com Date: Fri, 2 Nov 2007 04:24:53 EDT Subject: Re: [CR] Seat post shims To: classicrendezvous@bikelist.org

I have been considering using a shim along with a too-small chromed steel seat pin on one bike.

Has anyone had a problem with a shim simply sliding down into the seat tube when trying to insert the post? Seems like a rather difficult procedure to me.

BOB HANSON, ALBUQUERQUE, NEW MEXICO, USA

************************************** See what's new at http://www.aol.com

_______________________________________________

The Columns on Alamo Welcome to our bed and breakfast in San Antonio, Texas. Come fiesta with us! We offer off-street parking, and the downtown trolley stops just a 1/2 block away! All rooms have a private bath, TV and telephone. Wireless Internet Access available in all rooms (EXCEPT the Rockhouse Cottage) Please contact us if you have any questions, thanks! (210)271-3245 · (800)233-3364 · ArtLink@ColumnsSanAntonio.com