Re: [CR]1st gen S.R. seatpost

>I recently acquired a 1st gen Super Record seatpost and I'm wondering if
> some of the saddle clamp parts have been changed out. The only
> differences I see between these parts and those on my Record post is
> that the lower rail supports are alloy and the barrel nuts have concave
> ends. The upper rail clamps (steel) and the bolts are identical on both
> posts. According to Campy Cat. 17a, the upper rail clamps and the bolts
> should be unique on the S.R. post too (perhaps alloy and Ti?). Or were
> these changes pulled soon after it's introduction?
>
> Forgive me if this has been discussed before or it is common knowledge
> but I'm still learning the intricacies of Campy parts. Yes, I searched
> the archives.
>
> In a similar vein, how difficult is it to source these parts if I need
> to? One of the barrel nuts is incorrect and I'll have to find a
> replacement for that at the least.
>
> Thanks,
>
> Paul Kemp
> Katy, TX
> USA
>
> Confidentiality Warning: This message and any attachments are intended on
> ly for the use of the intended recipient(s), are confidential, and may be
> privileged.
> If you are not the intended recipient, you are hereby notified that any r
> eview, retransmission, conversion to hard copy, copying, circulation or o
> ther use of all or any portion of this message and any attachments is str
> ictly prohibited. If you are not the intended recipient, please notify th
> e sender immediately by return e-mail, and delete this message and any at
> tachments from your system.