At 7/23/2007 09:24 AM -0700, Jerome & Elizabeth Moos wrote:
>So anyone know a source for Whitworth wrenches that would fit a TDC
>HS? The locknut is smaller than 32mm, maybe close to 30 mm, though
>I doubt a 30 mm wrench will work. The adjustable cup is just a bit
>too big for a 40 mm wrench. I recently bought a Whitworth wrench
>set at a reasonable price, but it only goes up the 9/16 W, which
>isn't large enough.
I made one from flat stock years ago. But just the other day I was
at a distributor who has a huge box of the old Raleigh Multi
tools. http://bikesmithdesign.com/
If there is enough interest, at $5 ea., I could pick up a few. S&H would be $6 for Priority mail. 1st class would be $4 but I would wait till I had several buyers, then make a trip to the PO for enough stamps.
Or, I'd ship them free with purchase of a cotter press or Raleigh fixed cup tool.
Mark Stonich;
BikeSmith Design & Fabrication
5349 Elliot Ave S. - Minneapolis. MN 55417
Ph. (612) 824-2372 http://bikesmithdesign.com
http://mnhpva.org