There are two thin plain washers that go on the brake caliper pivot bolt- on either side of the of the inner arm. I think they are same diameter and also both .5mm thick. However one listmember tells me the outer of the two washers has a 6.5 mm hole while the innermost (closest to the spring) is a 7.0mm hole- at least on his. He kindly photographed this and I have the pic available. Is this just some drilling irregularity (or one washer a substitution) -are the washers supposed to be the same hole diameter and exactly alike? (It might be these are standard hardware store items I dunno)
Also need 2 dome nuts that go on the very end of front and rear brake pivot bolt. (Are these necessarily Campy SR or any will do?)
All of these parts needed close to NOS cond without chrome loss, rust, etc.