Subject: [CR]Nitto axle lamp holder

(Example: Component Manufacturers:Avocet)

Date: Sun, 30 Nov 2008 12:29:34 -0800
From: "erik" <threadfile@gmail.com>
To: classicrendezvous@bikelist.org
Subject: Subject: [CR]Nitto axle lamp holder


Hi all,

After not being able to find this I also make a very lightweight steel version of this mount. Same style, replaces the skewer end nut, it is 1" in diameter to fit almost all lights and handmade in USA by me.

Available in black or silver for $18 shipped. Let me know if you would like pictures or more info.

Thanks, Erik Reese Portland Oregon USA

---------- Forwarded message ---------- From: "David Bean" <beandk@rcn.com> To: "CR List (E-mail)" <classicrendezvous@bikelist.org> Date: Sun, 30 Nov 2008 11:04:06 -0500

There was an exchange involving the Nitto website about a week ago. At the bottom of this page: http://www16.ocn.ne.jp/~nitto210/list3otherwise.html<http://www16.ocn.ne.jp/%7Enitto210/list3otherwise.html> there is a neat gizmo that takes the place of the nut on the end of a quick release and provides a place to mount a [normally] handlebar-mounted headlamp except it's way down low. I don't see it on the English language Nitto pages. Anyone know if they're available in the States? Mark Stonich - R U interested in making them? (A bit more complicated would be making a similar gizmo for the lever end of a QR. Or a whole two-ended set...)

David Bean
Arlington, MA USA
beandk at are-see-enn dot com