Billy, I think what you have is not the later Hyperglide but the early Uniglide cassette. I believe that you can unthread the small cog using two chain whips (someone correct me if I am wrong). than the rest of the cogs slide of as one piece. You cannot use hyperglide versions as the groove configuration is different. On the uniglides all the slots are the same on the hyperglide you have the one slot that is larger. I have filed off the offending larger larger area on the cog body and it works fine on the Uniglide. I think, however you have to make sure you file off the rear facing edge rather than the front so that the cassette body does not move forward when you push down on the pedals. Hope I do not have this all wrong.... Edward Albert Chappaqua, New York, U.S.A.
On Sun, Dec 7, 2008 at 9:56 AM, <billydavid13@comcast.net> wrote:
> Hi all. This is an early DA cassette hub where the small cog threads on to
> lock the the other slide-on cogs in place. Once you remove the axle there's
> an 8 splined female bolt head instead of the later 10mm allen head. Is the
> re a tool made for unthreading this? Or something I can use for this purpos
> e? Does it, in fact, unthread? And can I then thread on a later freehu
> b unit to the old hub shell? Any info would be appreciated on or off list.
> Thanks. Billy Ketchum; Chicago, IL; USA.