Re: [CR]DT shifters too close to fork crown

(Example: Component Manufacturers:Campagnolo)

Date: Fri, 29 Aug 2008 00:35:37 -0600
From: "Mitch Harris" <mitch.harris@gmail.com>
To: wesoishi@aol.com
Subject: Re: [CR]DT shifters too close to fork crown
In-Reply-To: <8CAD7A45DF60A98-CA0-3C87@webmail-nf02.sysops.aol.com>
References: <MONKEYFOOD0g9S83w4b000042a0@monkeyfood.nt.phred.org>
cc: classicrendezvous@bikelist.org

On Thu, Aug 28, 2008 at 10:10 PM, <wesoishi@aol.com> wrote:
>
> "It is frightening at times having ones fingers inadvertently rub the tire a
> centimeter or two behind the almost-finger-sized gap between tire and fork
> crown, especially when wearing full-fingered gloves.
>
> It seems too likely that one's finger(s) could get pulled under the crown!!!"
>
> Does anyone else know of a person who wiped their tire from the wrong side of the fork and did an end-O?
>

Not the front tire, and not an endo, but one league night I was on my E.G. Bates circling the velodrome for slow warm up laps with a couple team mates when I reached down with my hand to brush off the rear wheel. But I reached a little low, didn't pay attention, and let my gloved hand get stuck between a Vittoria CX and the seat tube. I stopped so suddenly I disappeared from between my team mates. They looked back to see me teetering, about to fall over but a I gave a mighty tug and pulled my hand out. Ouch. What a maroon.

Mitch Harris
Little Rock Canyon, Utah, USA