Re: [CR] Need help: protecting frame from clamp-on parts and brake cable clips

(Example: Production Builders:Tonard)

X_CMAE_Category: 0,0 Undefined,Undefined
Date: Fri, 2 Oct 2009 10:49:20 -0400
From: "Christian M missionary" <hdarr@embarqmail.com>
To: Mark Lawrence <mark.lawrence@firstreadthis.com>
In-Reply-To: <C1A9A0C6939C944F9486C72F7F253439C38278F582@PEMEXMBXVS01.jellyfishnet.co.uk.local>
Cc: classicrendezvous@bikelist.org
Subject: Re: [CR] Need help: protecting frame from clamp-on parts and brake cable clips


Greetings,and question at the end

This indeed was discussed and I just happened to be putting bits on a Zeus at the time. Use 3M packing tape with the adheasive toward the clamp(s) then use an exacto knife to trim. I used a neele point double blade. Looks neat and no black adheasive muck from friction tape and no water retention from cotton. handlebar tape.

Now to my question. I have Campagnolo brake clips that I am going to put on. The clips have a stamping roll or burr on the inside edge. Has anyone deburred these first? I have been a little hesitant because they are thin and it would be easy to twist them. On the other hand the burrs may dig into the paint even with 3m packing tape.

Howard Darr
Kinsman OH USA