[CR] Badge Adhesive

(Example: Racing:Beryl Burton)

Date: Mon, 26 Oct 2009 11:04:25 -0700
From: "sean flores" <seaneee175@gmail.com>
To: <classicrendezvous@bikelist.org>
Subject: [CR] Badge Adhesive


Apologies if these two techniques have been mentioned before as I've been away and I'm just catching up.

Two methods I find are really great. One is more permanent than the other, but read on.

Rubber Cement is the less permanent of the two. Now before you go poo pooing the idea, there is a certain way you have to do it for it to work correctly. Apply one layer to the rear of the badge and one to the bicycle, go beyond the actual size of the badge to ensure coverage. LET IT DRY, but no longer than an hour. At this point you can apply a second coat for a little more security, but this is optional. Once dry, press into play. Make sure you get it right, as if you move the badge or lift it up, you have to start over- as it weakens the bond. Hold in place for about 30 seconds with a decent amount of pressure. You can also zip tie it in place for it to bond. Let it sit overnight and you will have a very strong bond. If needed, you can use mineral spirits to loosen and remove.

Technique number two, a more permanent solution, is exactly the same as above, with two exceptions. First, use contact cement. The big brother of rubber cement. Also, you DO NOT need a second layer. Apply the same way, allowing the adhesive to dry before applying.

Cleanup of the excess can be done with your thumb, a rubber cement pickup (available at most art stores) or Mineral Spirits. A product called Bestine, a thinner for rubber and contact cement is also great, just wear gloves.

Sean Flores
San Francisco, CA