Re: [CR] Facing and reaming

(Example: Production Builders:Peugeot)

From: "Andrew R Stewart" <onetenth@earthlink.net>
To: <mrrabbit@mrrabbit.net>, verktyg <verktyg@aol.com>
References: <259181072.20091103104410@rogers.com> <F62E80D05B794DD7A6F64BE7E5D66CB3@ARSPC> <4AF0871D.1050301@aol.com> <1257278618.4af08c9a95f96@www.mrrabbit.net>
In-Reply-To: <1257278618.4af08c9a95f96@www.mrrabbit.net>
Date: Tue, 3 Nov 2009 17:26:47 -0500
Cc: Classicrendezvous@bikelist.org
Subject: Re: [CR] Facing and reaming

Robert- The tools I use and was referring to are very much on topic. The OP did mention "an old frame".

----- Original Message -----
From: mrrabbit@mrrabbit.net
To: verktyg
Cc: Andrew R Stewart

<Classicrendezvous@bikelist.org> Sent: Tuesday, November 03, 2009 3:03 PM Subject: Re: [CR] Facing and reaming

> Was this ever even ON-TOPIC?
>
> It appears from the beginning to be basically a general bicycle mechanics
> thread which is covered quite well by at least two other websites that
> have
> forums for bicycle mechanics for bike vintage and new bikes. Took a
> slight
> turn to ON-TOPIC for a post or two and then went OFF-TOPIC again.
>
> =8-)
>
> If this had been a topic from the beginning about taking a vintage frame
> and
> reaming it up to todays common diameters, etc. in order to fit newer
> headsets -
>
> then you wouldn't have heard from me...
>
> =8-)
>
>
> Robert Shackelford
> San Jose, CA USA

Andrew R Stewart
Rochester, NY