At 2/8/2010 04:26 PM +0200, Amir Avitzur wrote:
>Did Campy bend their Large flange hub flanges.
They were machined slightly conical. If you lay a straight edge along the inside of a front flange there is a gap of about 2mm at the bulge for the bearing race. Much less of a gap in the rear.
Mark Stonich;
BikeSmith Design & Fabrication
5349 Elliot Ave S. Minneapolis, Minnesota 55417 USA
Ph. (612) 824-2372 http://bikesmithdesign.com
http://mnhpva.org