We have originals, cone and axles.....But they are in our warehouse 40 plus miles away. We'll bringing these stocks to SB, from there we'll listing these hub parts @ http://www.cafedevelo.com
Baron C.........aAnd the gang!!
Cafe de velo
The bike stand / The bike stand 2.0
Santa Barbara Ca.
> Date: Mon, 15 Feb 2010 03:37:27 +0000
> From: billydavid13@comcast.net
> To: Jon@FAI.US
> CC: classicrendezvous@bikelist.org
> Subject: Re: [CR] WTB QR Axle, Cone, spacers, nuts for Campy GS Hubs
>
> Hi John. Campy used 26tpi threads, 10mm rear, 9mm front. Rear bearings were 1/4"; front either 3/16" or 7/32". Almost everyone else used 3/16" for the front. Most non-Italian axles have 1 thread per millimeter [e.g.: 10mmx1.0mm] The other issue is the ramp on the cones and the hub races. These vary quite a bit. You might get away w/ using a metric axle set in a Campy hub but the cones should have a ramp profile similar to a Campy. Good luck. Billy Ketchum; Chicago, IL USA.
> ----- Original Message -----
> From: "Jon M. Crate" <Jon@FAI.US>
> To: classicrendezvous@bikelist.org
> Sent: Sunday, February 14, 2010 8:34:18 PM GMT -06:00 US/Canada Central
> Subject: [CR] WTB QR Axle, Cone, spacers, nuts for Campy GS Hubs
>
> I bought two sets of NOS 60s vintage Campy GS hubs and am looking for a source
> of compatible quick release axles, cones, spacers and nuts.
> I have been thinking compatibility should be pretty wide, no?
> If so, shouldn't these work?
> http://www.loosescrews.com/
> <http://www.loosescrews.com/index.cgi?d=single&c=Hub&sc=Axle%20Sets&tc=Rear%20Ca
> mpy&item_id=CA-1281018&id=683109620079>
> &c=Hub&sc=Axle%20Sets&tc=Rear%20Campy&item_id=CA-1281018&id=683109620079
> they do not have fronts, I do not need NOS, and hope for less $$ outlay.
>
> many thanks,
>
> Jon M. Crate
> In snowy Marietta, Georgia USA