Consider using a large vise... It allows you to apply gentle controlled pressure very evenly. To protect the bearing face (do one side at a time), I would find a small piece of wood board placed between vise jaws and parts. This set up helps but does not guarantee concentric inward movement so you have to monitor the progress carefully. But it works!
Dale Brown cycles de ORO, Inc. 1410 Mill Street #100 Greensboro, North Carolina 27408 USA 336-274-5959 http://www.cyclesdeoro.com http://www.classicrendezvous.com http://www.carolinacup.com \u201cLife is like riding a bicycle. To keep your balance you must keep moving\u201d A.Einstein
-----Original Message----- From: Paul Walker <starsinmypockets@gmail.com> To: classicrendezvous@bikelist.org Sent: Tue, May 4, 2010 12:12 pm Subject: [CR] Pressing in Viscount bearings...
Hey. Any tips on pressing new bearings into Viscount / Lambert BB shells? I have a park headset press, and imagine that I need to find some pipe of the proper diameter to contact the outside of the bearings. Someone mentioned using an arbor press, but I'm unfamiliar with this type of press. Thoughts?
Paul Walker
Philadelphia, Pennsylvania
USA