While on the subject of hub axles, does anyone know of readily available replacement axles to fit the classic 80's Mavic hubs? I have picked up a couple of pairs with 130 and 135 rear spacing that needs to be changed to 126. Also, is there a standard sealed bearing replacement that fits these hubs?
Regards,
Jerry Moos
Houston, TX
> Either axle will work for a five speed. Adjust the axle spacers to provide
> for minimal dish without the chain touching the frame when shifting into
or
> out of the smallest cog.
>
> Peter Jon White
> Peter White Cycles
> 24 Hall Rd.
> Hillsborough, NH 03244
> 603 478 0900 Phone
> 603 478 0902 Phax
> http://www.PeterWhiteCycles.com
>
>
> ----- Original Message -----
> From: <FujiFish1@aol.com>
> To: <classicrendezvous@bikelist.org>
> Sent: Sunday, March 14, 2004 1:51 AM
> Subject: [CR]Correct length Campy rear hub axle?
>
>
> > Hello all,
> > I have two Campagnolo (Nuovo) Record rear axles, in 129.2mm and 134mm
> > total lengths, and I'm hoping that one is correct for my project.
> >
> > Can someone possibly tell me the correct length axle needed for the
> > following conditions?:
> > -Approx. 1977 Campy N.Rec. rear road hub, large flange (double
> drilled
> > by Schwinn ... what year are these?).
> > -Zeus 2000 aluminum 5 speed freewheel, measuring 24.95mm in
thickness
> > (outside face to inside face), with a space of about 5.65mm between cogs
> (c-c).
> > -1972 Italian road frameset, rear spacing rests at 121.7mm.
> > -Campy N.R. double crankset (no date, 144bcd, if it matters)
> >
> > Or, is there a known rule about using spacers to adjust how close the
> > outermost freewheel cog sits in relation to the inside face of the
> dropout?
> >
> > Thanks very much for the help ... as usual!
> >
> > Ciao,
> > Mark Agree
> > Southfield MI